Dynaflite PT-19 Manuel d'utilisateur télécharger pdf (Page 10)

needed, to get the center of each bulkhead to align

properly. When you are satisfied that everything is

aligned properly, glue the tail together. Also glue

bulkhead F and G to the fuselage

sides.

17. Glue the top ply part of bulkheads F and G

into position. Note that the top part of F goes in front

of the lower part of F. The rear of the top part of G

goes 1/2" in

front

of the lower part of G.

18. Cut three 1 /4" x 1 /2" x 24" balsa sticks to a

length of 19". Glue these top rear stringers to

bulkheads E, F and G.

21. Use leftover 1/4" x 1/2" balsa sticks to

frame between the bottom stringers at bulkhead E.

Just tack glue them into position at this time

as you

may need to adjust them when the wing is fitted.

19. Notch the bottom stringers to accept the die-

cut 1/8" ply tailwheel plate. The correct position for

the bracket will allow the 1/4" x 1/2" stringers,

added in the next step, to extend 1 /4" below the

bottom of the 1/4" x 15/16" side stringers. When

satisfied with the fit glue the die-cut plate into

position with 6-minute epoxy.

20. Cut two 1/4" x 1/2" x 30" balsa sticks to a

length of 28-1/2". Fit and glue these bottom

stringers into position. You will need to notch them at

bulkheads F and G. They should extend 1 /4" below

the 1/4" x 15/16" side stringers. You can let them

extend into the area where the tailwheel plate is

mounted if desired.

22. Glue the 1 /4" ply wing hold down plate

into

place with 6-minute epoxy. Use some leftover

1/4" x 3/8" basswood sticks to reinforce above the

ply plate.

23. Roll the fuselage over and glue Bulkheads

B-1 and D-1 into place. Bulkhead B-1 is glued

3-1/16" behind Bulkhead B and bulkhead D-1

glued 2" behind bulkhead D.

24. Cut and glue the stringers between bulkheads

B and B-1 and between bulkheads D and D-1.

Use

leftover

1/4" x 1/2" balsa sticks.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Dynaflite PT-19 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement aérien Dynaflite PT-19