Dynaflite PT-19 Manuel d'utilisateur Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
Never point the tip of a CA bottle toward your face
and be especially careful when you unclog a CA tip.
Hobbico CA Applicator Tips (HCAR3780) are highly
recommended and will help keep the bottle from
clogging. Keep paper towels or tissues close by to
immediately absorb excess CA dropped on your
model or work area. Read all the warning labels on
your CA bottle. CA Accelerator is a chemical that
you can spray over uncured CA to make it cure
immediately. A mist spray of accelerator will do the
job. Do not inhale the vapors! Some modelers
"preprime" the parts to be glued with accelerator,
join them, then add the CA. This way the CA is
guaranteed to cure immediately. This prepriming is
especially handy when you use thin CA because it
will cure before all of the glue soaks into the wood
away from the glue joint. We do not recommend
you build your entire model with this method and
use accelerator only when necessary. Often,
overspray from accelerator used hours or even days
earlier on nearby glue joints will cause the CA you
use on the next step to cure prematurely and
unexpectedly - so be careful!
Aliphatic Resin - Resin glues require that parts be
pinned or clamped together while the glue dries/-
typically 15-30 minutes. Resin glues are very
strong and work well with balsa and plywoods.
Epoxy - Epoxy glues are the strongest but require the
most time to cure. Six-minute epoxy cures the fastest;
it sets within six minutes but is not fully cured for one
hour or more. Thirty-minute epoxy is the strongest as
it allows the epoxy to soak into the wood thoroughly.
While
it
sets
within
30
minutes,
it
will
not be fully
cured for two or more hours.
Inch Scale
Fuse = Fuselage
Ply = Plywood
" = Inches
Stab
= Horizontal Stabilizer
LE = Leading edge (front)
TE = Trailing edge (rear)
Balsa Basswood Plywood
Metric Scale
5
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire